Round Mold for Epoxy Casting Disassemblable

Product detailed description

Round mold for repeated production of epoxy castings in combination with wood and other materials. Perfectly demoldable, easy to disassemble and fold back. Suitable for clocks, side tables, etc.

Material: laminate + ABS

Sizes:

• Circle diameter 30 cm (base square 400 x 400 mm)
• Circle diameter 40 cm (base square 500 x 500 mm)
• Circle diameter 50 cm (base square 600 x 600 mm)

In the case of an atypical request, it is possible contact us.

Preparation procedure for epoxy coating:

• The laminate underlay needs to be separated (either stick polypropylene tape or a chemical separator).
• Cover the inside of the ABS edge with polypropylene tape.
• Press the silicone sealant into the milled circular groove in the laminate underlay. Give enough material to fill the groove and prevent epoxy from flowing into it.
• Don't forget to cover the joined edges of the ABS edges with tape.
• Press the ABS edge covered with tape into the sealant in the groove and then smooth the silicone sealant from inside and outside of the mold.
• Allow to cure according to the instructions of the silicone used (usually 1 day).
• Insert the potted objects into the mold (if necessary, weigh them down or ensure that they do not float, if necessary).
• Cover with well homogenized resin.

Demolding procedure:

• After curing, cut the silicone on the outside of the ABS edge (up to that edge) with a knife and, if necessary, remove this silicone.
• Cut the tape on the joined sides of the ABS edge.
• Lightly tap the ABS edge from the inside (trying to get air between the ABS edge and the casting).
• Forcefully, but carefully, pull the ABS edge out of the groove.
• By tapping over a block of wood, tap the side of the casting with a hammer until it separates from the laminate backing.

The package contains 1 piece of laminate base square with a milled circle of the given diameter + 1 piece of ABS edge with corresponding length.